300-115 Exam Questions - Online Test

300-115 Premium VCE File

Learn More 100% Pass Guarantee - Dumps Verified - Instant Download
150 Lectures, 20 Hours

Proper study guides for Most recent Cisco SWITCH Implementing Cisco IP Switched Networks certified begins with Cisco 300 115 switch preparation products which designed to deliver the Simulation ccnp switch 300 115 dumps pdf questions by making you pass the 300 115 pdf test at your first time. Try the free ccnp routing and switching switch 300 115 official cert guide demo right now.

P.S. Simulation 300-115 torrent are available on Google Drive, GET MORE: https://drive.google.com/open?id=1V3EjdNAQ30Y30Ko-7P1GWcqZQ5NzdlhZ

New Cisco 300-115 Exam Dumps Collection (Question 15 - Question 24)

Q1. Refer to the exhibit.

Which two statements about the network environment of the device that generated this output are true? (Choose two.)

A. The exhibit hello and hold timer values are in use.

B. The standby router can take the active HSRP if it fails to receive a hello packet from the active router within 1.616 seconds.

C. The priority value of the HSRP group is 1.

D. HSRP version 2 is in use.

E. The standby router can take the active HSRP role if it fails to receive a hello packet from the active router within 10 seconds.

Answer: A,E

Q2. Which file lists all of the configured VLANs on a switch?

A. flash:vlan.dat

B. nvram:vlans.xml

C. flash:vlans.txt

D. nvram:vlan.txt

E. flash.config.txt

F. flash:vlan.xml

Answer: A

Q3. Which option is the minimum frame size of an 802.1Qframe?

A. 64 bytes

B. 68 bytes

C. 1518 bytes

D. 1522 bytes

Answer: B

Q4. Refer to the exhibit.

Which two statement can be derived from the output of the show standby command? (Choose two.)

A. R2 Fai/O regains mastership when the link comes back up.

B. R2 becomes the active router after the hold time expires.

C. Router with IP 10.10 1 3 is active because it has a higher IP address.

D. If Fa0/0 is shut down, the HSRP priority on R2 becomes 80.

E. R2 is using the default HSRP hello and hold timers.

Answer: D,E

Q5. Which command configures VLAN 99 as an untagged VLAN on a trunk?

A. switchport access vlan 99

B. switchport trunk pruning vlan except 99

C. switchport trunk allowed vlan 99

D. switchport trunk native vlan 99

Answer: D

Q6. Refer to the exhibit. What is the result of setting GLBP weighting at 105 with lower threshold 90 and upper threshold 100 on this router?

A. Only if both tracked objects are up will this router will be available as an AVF for group 1.

B. Only if the state of both tracked objects goes down will this router release its status as an AVF for group 1.

C. If both tracked objects go down and then one comes up, but the other remains down, this router will be available as an AVF for group 1.

D. This configuration is incorrect and will not have any effect on GLBP operation.

E. If the state of one tracked object goes down then this router will release its status as an AVF for group 1.

Answer: B

Q7. Which statement is true when one of its virtual gateway redundancy with an AVF has failed?

A. If an AVF has failed, one of the primary virtual forwarders in the listen state assumes responsibility for the virtual MAC address.

B. If an AVF has failed, one of the secondary virtual forwarders in the listen state assumes responsibility for the virtual MAC address.

C. If an AVF has failed, one of the secondary virtual forwarders in the listen state will also fail.

D. If an AVF has failed, one of the primary virtual forwarders in the listen state will also fail.

Answer: B

Q8. Which two statements about 802. 1q are true? (Choose two )

A. It encapsulates the original Ethernet frame and adds a VLAN identifier.

B. It increases the maximum size an Ethernet frame to 1094 bytes.

C. It is a Cisco proprietary protocol.

D. When It is enabled, it forces a recalculation of the frame check sequence field.

E. It supports 8-byte VLAN identifiers.

F. It adds a 32-bit field to the Ethernet frame between the source MAC address and length fields.

Answer: B,E

Q9. Which option is the minimum number of bindings that the DHCP snooping database can store?

A. 1000 bindings

B. 2000 bindings

C. 5000 bindings

D. 8000 bindings

Answer: D

Q10. Which IOS configuration command is required to configure a VLAN as a private VLAN?

A. switch(config-vlan)# private-vlan common

B. switch(config-vlan)# private-vlan private

C. switch(config-vlan)# private-vlan primary

D. switch(config-vlan)# private-vlan transparent

Answer: C

100% Most recent Cisco 300-115 Questions & Answers shared by Surepassexam, Get HERE: https://www.surepassexam.com/300-115-exam-dumps.html (New 522 Q&As)