300-115 Exam Questions - Online Test

300-115 Premium VCE File

Learn More 100% Pass Guarantee - Dumps Verified - Instant Download
150 Lectures, 20 Hours

Exam Code: 300 115 switch pdf (Practice Exam Latest Test Questions VCE PDF)
Exam Name: SWITCH Implementing Cisco IP Switched Networks
Certification Provider: Cisco
Free Today! Guaranteed Training- Pass cbt nuggets ccnp switch 300 115 download Exam.

P.S. Highest Quality 300-115 free samples are available on Google Drive, GET MORE: https://drive.google.com/open?id=1WzeEi-YMJ4-9dZHT1BGDd5p41JZ_7zCq

New Cisco 300-115 Exam Dumps Collection (Question 6 - Question 15)

New Questions 6

Which two restrictions of the port security feature are true? (Choose two.)

A. It is not supported on destination SPAN ports.

B. It is not supported on EtherChannel port-channel interfaces.

C. Static port MAC address assignments are not supported

D. A single device can learn a maximum of three sticky MAC addresses.

E. It is not supported on PVLAN ports.

Answer: A,C

Explanation: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12-2SY/configuration/guide/sy_swcg/port_security.html#84716

New Questions 7

Which two statements about vrrp are true? (Choose Two)

A. Preemption is not supported

B. It support clear text authentication only

C. It uses a shared vip to support default gateway redundancy

D. It requires each device in the group to participate in the same dynamic routing protocol.

E. It can use a single virtual address to provide default gateways redundancy

Answer: D,E

New Questions 8

An enterprise network has port security sticky enabled on all access ports. A network administrator moves a PC from one office desk to another After the PC is moved, the network administrator clears the port security on the new network switch port connecting to the PC, but the port keeps going back into err-disabled mode. Which two factors are possible causes of this issue? (Choose two)

A. Port security sticky exists on the new network switch port.

B. Port security sticky is disabled on the new network switch port.

C. Port security must be disabled on all access ports.

D. Port security is still enabled on the older network switch port.

E. Port security sticky is still enabled on the older network switch port.

Answer: A,E

New Questions 9

Which describes the default load balacing scheme used by the Gateway Load Balancing Protocol (GLBP)?

A. Per host using a strict priority scheme

B. Per session using a round-robin scheme

C. Per session using a strict priority scheme

D. Per GLBP group using a strict priority scheme

E. Per host basis using a round robin-scheme

F. Per GLBP group using a round-robin scheme

Answer: E

New Questions 10

Which four LACP components are used to determine which hot-standby links become active after an interface failure within an EtherChannel bundle? (Choose four.)

A. LACP system priority

B. LACP port priority

C. interface MAC address

D. system ID

E. port number

F. hot-standby link identification number

G. interface bandwidth

Answer: A,B,D,E

New Questions 11

Which feature rate-limits DHCP traffic?

A. DHCP Snooping

B. DHCP Acknowledge

C. DHCP Request

D. DHCP Spoofing

Answer: A

New Questions 12

switch#show standby

Virtual IP address is X.X.X.X Hello time 3 sec, hold time 10 sec Preemption disabled

Active router is X.X.X.3 priority 85 Standby router is local

Priority 90 (configured 90)

Track interface faX/X state decrement 10 (Choose two)

A. The link will take over when .....

B. X.X.X.3 is active becuse it has higher IP address

C. when faX/x is down praiority will be 80

D. it is using default hello and hold values

Answer: C,D

New Questions 13

Which two statements about default FHRP behavior are true? (Choose two)

A. A backup GLBP active virtual gateway can become active only if the current active virtual gateway fails.

B. Preemption is enabled by default.

C. Unless specifically Configured, the priority of an HSRP router is 200.

D. A standby HSRP router becomes active if it has a higher priority than the priority of the current active router.

E. A VRRP backup virtual router becomes the master router if its priority is higher than the priority of the current master router.

Answer: A,E

New Questions 14

Which two conditions must be met to establish a Layer 2 EtherChannel? (Choose two.)

A. SPAN must be disabled on the ports.

B. LAN ports in the EtherChannel must be contiguous.

C. The trunking protocol must be the same for all links in the EtherChannel.

D. All ports in the EtherChannel must be on the same module.

E. All ports in the EtherChannel must operate in half duplex.

Answer: A,C

New Questions 15

What happens if you apply this command "vlan dot1q tag native"?

A. packet will be dropped

B. packet go to defautl vlan

C. packet go to native vlan

Answer: A

100% Updated Cisco 300-115 Questions & Answers shared by Surepassexam, Get HERE: https://www.surepassexam.com/300-115-exam-dumps.html (New 416 Q&As)