300-101 Exam Questions - Online Test

300-101 Premium VCE File

Learn More 100% Pass Guarantee - Dumps Verified - Instant Download
150 Lectures, 20 Hours

It is impossible to pass Cisco 300 101 dumps exam without any help in the short term. Come to Testking soon and find the most advanced, correct and guaranteed Cisco ccnp 300 101 pdf practice questions. You will get a surprising result by our Updated ROUTE Implementing Cisco IP Routing practice guides.

P.S. Precise 300-101 faq are available on Google Drive, GET MORE: https://drive.google.com/open?id=1PpU_6uksdH22QCdKrEcnWjPvNnVGXp8m

New Cisco 300-101 Exam Dumps Collection (Question 3 - Question 12)

Question No: 3

Which statement is true?

A. RADIUS uses TCP, and TACACS+ uses UDP.

B. RADIUS encrypts the entire body of the packet.

C. TACACS+ encrypts only the password portion of a packet.

D. TACACS+ separates authentication and authorization.

Answer: D

Question No: 4

Which functionality is required within an IP router that is situated at the boundary of an IPv4 network and an IPv6 network to allow communication between IPv6-only and IPv4-only nodes?

A. Autoconfiguration

B. Automatic 6to4 Tunnel

C. Automatic 6to4 Relay

D. Network Address Translator-Protocol Translator (NAT-PT)

E. Intrasite Automatic Tunnel Address Protocol (ISATAP)

Answer: D

Question No: 5

Refer to the exhibit.

Which statement about the configuration is true?

A. This configuration is incorrect because the MTU must match the ppp-max-payload that is defined.

B. This configuration is incorrect because the dialer interface number must be the same as the dialer pool number.

C. This configuration is missing an IP address on the dialer interface.

D. This configuration represents a complete PPPoE client configuration on an Ethernet connection.

Answer: D

Question No: 6

Your Company trainee asks you, in the context of IPv6 and OSPF, what best describes a type 9 LSA? What should you tell her?

A. Link LSA

B. Interarea prefix LSA for ABRs

C. Router LSA

D. Switch LSA

E. Intra-area prefix LSA

F. None of the above

Answer: E

Question No: 7

Refer to the exhibit. A network engineer executes the show ipv6 ospf database command and is presented with the output that is shown. Which flooding scope is referenced in the link-state type?

A. link-local

B. area

C. As (OSPF domain)

D. reserved

Answer: B

Question No: 8

Refer to exhibit:

Why is the default route not removed when 172.20.20.2 stops replying to ICMP echos?

A. The source-interface is configured incorrectly.

B. the threshold value is wrong

C. The destination must be 172.30.30.2 for icmp-echo.

D. The default route is missing the track feature.

Answer: D

Question No: 9

Refer to the Exhibit.

What is the correct configuration to enable router P4 to exchange RIP routing updates with router P1 but not with router P3?

A. P4(Config)# interface fa0/0P4(Config-if)# neighbor 192.168.10.3P4(config-if)# passive- interface fa0/0

B. P4(config)# router ripP4(config-router)#neighbor 192.168.10.3P4(Config- router)#passive-interface fa0/0

C. P4(config)# interface fa0/0P4(config-if)# neighbor 192.168.10.3P4(config-if)# passive interface192.168.10.34

D. P4(config)# router ripP4(config-router)# neighbor 162.168.10.34 no broadcastP4(config- router)# passive-interface fa0/0

Answer: B

Explanation:

When you configure router P1 to be the nieghtobr of P4 with a passive interface, the RIP routing updates will be exchanged with the neighbor only.

Question No: 10

A network engineer is asked to create an SNMP-enabled proactive monitoring solution to ensure that jitter levels remain between particular boundaries. Which IP SLA option should the engineer usa?

A. threshold

B. frequency

C. verify-data

D. timeout

Answer: A

Question No: 11

Refer to the exhibit.

A. Interface authentication must be configured.

B. The routing processes must be configured with an area ID.

C. IP unicast routing must be enabled.

D. IPv4 addresses must be applied to the interfaces.

Answer: C

Question No: 12

An engineer is using a network sniffer to troubleshoot DHCPv6 between a router and hosts on the LAN with the following configuration:

Interface Ethernet0

Ipv6 dhcp server DHCPSERVERPOOL rapid-commit

!

Which two DHCPv6 messages will appear in the sniffer logs?

A. reply

B. request

C. advertise

D. acknowledge

E. solicit

F. accept

Answer: A,E

100% Updated Cisco 300-101 Questions & Answers shared by Certifytools, Get HERE: https://www.certifytools.com/300-101-exam.html (New 487 Q&As)