300-101 Exam Questions - Online Test

300-101 Premium VCE File

Learn More 100% Pass Guarantee - Dumps Verified - Instant Download
150 Lectures, 20 Hours

Master the 300 101 vce ROUTE Implementing Cisco IP Routing content and be ready for exam day success quickly with this Testking ccnp routing and switching route 300 101 complete video course sample question. We guarantee it!We make it a reality and give you real 300 101 route questions in our Cisco ccnp routing and switching route 300 101 complete video course braindumps.Latest 100% VALID Cisco ccnp route 300 101 dumps pdf Exam Questions Dumps at below page. You can use our Cisco ccnp dumps 300 101 braindumps and pass your exam.

P.S. Printable 300-101 faq are available on Google Drive, GET MORE: https://drive.google.com/open?id=1lWZpAR5vb8lOApmzhHWMzXffOPhCR-LL

New Cisco 300-101 Exam Dumps Collection (Question 13 - Question 22)

Question No: 13

Refer to Exhibit:

Which statement about the configuration on the Cisco router is true?

A. The router sends only NTP traffic, using the loopback interface, and it disables eth0/0 from sending NTP traffic.

B. Eth0/0 sends NTP traffic on behalf of the loopback interface

C. The router sends only NTP traffic, using the eth0/0 interface, and it disables loopback0 from sending NTP traffic.

D. The router never sends NTP traffic, as using the loopback interface for NTP traffic is not supported on IOS routers.

Answer: C

Question No: 14

A network engineer configures two connected routers to run OSPF in Area 0; however, the routers fail to establish adjacency. Which option is one of the caused for this issue?

A. Area numbers match.

B. OSPF process numbers do not match on both neighbor routers.

C. The Same MTU sizes are configured on both sides.

D. The Same OSPF router IDs are configured on both routers.

Answer: B

Question No: 15

Scenario:

You have been asked to evaluate an OSPF network setup in a test lab and to answer questions a customer has about its operation. The customer has disabled your access to the show running-config command.

How many times was SPF algorithm executed on R4 for Area 1?

A. 1

B. 5

C. 9

D. 20

E. 54

F. 224

Answer: C

Question No: 16

If you want to migrate to IS-IS network to another routing protocol with?

A. UDP

B. EIGRP

C. OSPF

D. RIP

E. internal BGP

F. TCP/IP

Answer: B,C

Question No: 17

Which two statements about OSPF E1 routes are true? (Choose two)

A. They are preferred over interarea routes

B. They use the OSPF cost from redistribution and the OSPF cost to the ASBR.

C. They are preferred over E2 routes

D. They use only the OSPF cost to the ASBR

E. They use only the OSPF cost from redistribution

Answer: B,C

Explanation: http://blog.ine.com/2011/04/04/understanding-ospf-external-route-path- selection/

Question No: 18

Which switching method is used when entries are present in the output of the command show ip cache?

A. fast switching

B. process switching

C. Cisco Express Forwarding switching

D. cut-through packet switching

Answer: A

Topic 2, Layer 2 Technologies

13.Prior to enabling PPPoE in a virtual private dialup network group, which task must be completed?

A. Disable CDP on the interface.

B. Execute the vpdn enable command.

C. Execute the no switchport command.

D. Enable QoS FIFO for PPPoE support.

Question No: 19

A company has just opened two remote branch offices that need to be connected to the corporate network. Which interface configuration output can be applied to the corporate router to allow communication to the remote sites?

A. interface Tunnel0 bandwidth 1536

ip address 209.165.200.230 255.255.255.224

tunnel source Serial0/0 tunnel mode gre multipoint

B. interface fa0/0 bandwidth 1536

ip address 209.165.200.230 255.255.255.224

tunnel mode gre multipoint

C. interface Tunnel0 bandwidth 1536

ip address 209.165.200.231 255.255.255.224

tunnel source 209.165.201.1 tunnel-mode dynamic

D. interface fa 0/0 bandwidth 1536

ip address 209.165.200.231 255.255.255.224

tunnel source 192.168.161.2

tunnel destination 209.165.201.1 tunnel-mode dynamic

Answer: A

Question No: 20

Which two statements about Frame Relay LMI autosense are true on a Router? (Choose two)

A. It requires the LMI type to be explicitly configured.

B. It operates on Frame Relay DTE interfaces.

C. It operates on Frame Relay DCE interfaces.

D. It operates when the line is up by the line protocol is down.

E. It requires the line protocol to be up.

Answer: B,D

Explanation: https://www.cisco.com/c/en/us/td/docs/ios/12_2/wan/configuration/guide/fwan_c/wcffrely.ht ml

Question No: 21

Which type of traffic does DHCP snooping drop?

A. discover messages

B. DHCP messages where the source MAC and client MAC do not match

C. traffic from a trusted DHCP server to client

D. DHCP messages where the destination MAC and client MAC do not match

Answer: B

Question No: 22

Which value does a Cisco router use as its default username for CHAP authentication?

A. ppp

B. Cisco

C. its own hostname

D. chap

Answer: C

Explanation: https://www.cisco.com/c/en/us/support/docs/wan/point-to-point-protocol-ppp/25647-understanding-ppp-chap.html

100% Renewal Cisco 300-101 Questions & Answers shared by 2passeasy, Get HERE: https://www.2passeasy.com/dumps/300-101/ (New 745 Q&As)