New Questions 7

Review the Rule Base displayed.

For which rules will the connection templates be generated in SecureXL?

A. Rules 2 and 5

B. Rules 2 through 5

C. Rule 2 only

D. All rules except Rule 3

New Questions 8

You are MegaCorpu2021s Security Administrator. There are various network objects which must be NATed. Some of them use the Automatic Hide NAT method, while others use the Automatic Static NAT method. What is the rule order if both methods are used together? Give the BEST answer.

A. The Administrator decides the rule order by shifting the corresponding rules up and down.

B. The Static NAT rules have priority over the Hide NAT rules and the NAT on a node has priority over the NAT on a network or an address range.

C. The Hide NAT rules have priority over the Static NAT rules and the NAT on a node has priority over the NAT on a network or an address range.

D. The rule position depends on the time of their creation. The rules created first are placed at the top; rules created later are placed successively below the others.

New Questions 9

MegaCorp is using SmartCenter Server with several gateways. Their requirements result in a heavy log load. Would it be feasible to add the SmartEvent Correlation Unit and SmartEvent Server to their SmartCenter Server?

A. No. SmartCenter SIC will interfere with the function of SmartEvent.

B. No. If SmartCenter is already under stress, the use of a separate server for SmartEvent is recommended.

C. No, SmartEvent and Smartcenter cannot be installed on the same machine at the same time.

D. Yes. SmartEvent must be installed on your SmartCenter Server.

New Questions 10

Which command will only show the number of entries in the connection table?

A. fw tab -t connections -s

B. fw tab -t connections -u

C. fw tab -t connections

D. fw tab

New Questions 11

Match the ClusterXL modes with their configurations. Exhibit:

A. A-2, B-3, C-4, D-1

B. A-2, B-3, C-1, D-5

C. A-3, B-5, C-1, D-4

D. A-5, B-2, C-4, D-1

New Questions 12

The connection to the ClusterXL member u2021Au2021 breaks. The ClusterXL member u2021Au2021 status is now u2021downu2021. Afterwards the switch admin set a port to ClusterXL member u2021Bu2021 to u2021downu2021. What will happen?

A. ClusterXL member u2021Bu2021 also left the cluster.

B. ClusterXL member u2021Bu2021 stays active as last member.

C. Both ClusterXL members share load equally.

D. ClusterXL member u2021Au2021 is asked to come back to cluster.

New Questions 13

Which of the following is NOT defined by an Access Role object?

A. Source Network

B. Source Machine

C. Source User

D. Source Server

New Questions 14

Which file gives you a list of all security servers in use, including port number?

A. $FWDIR/conf/conf.conf

B. $FWDIR/conf/servers.conf

C. $FWDIR/conf/fwauthd.conf

D. $FWDIR/conf/serversd.conf

New Questions 15

You want to store the GAiA configuration in a file for later reference. What command should you use?

A. write mem <filename>

B. show config u2013f <filename>

C. save config u2013o <filename>

D. save configuration <filename>

New Questions 16

What scenario indicates that SecureXL is enabled?

A. Dynamic objects are available in the Object Explorer

B. SecureXL can be disabled in cpconfig

C. fwaccel commands can be used in clish

D. Only one packet in a stream is seen in a fw monitor packet capture