NEW QUESTION 1
You experience an issue on a Cisco Nexus 7700 Series switch. You must gather detailed information about the system state and the configuration of the switch. Which command should you run?

• A. switch# show logging > bootflash:Log.txt
• B. switch# show tech-support > bootflash:Log.txt
• C. switch# show running-config > bootflash:Log.txt
• D. switch# show system > bootflash:Log.txt

Answer: B

NEW QUESTION 2
What is the status of FC interface associated with ethernet 1/5 indicate?

• A. Trunk VSAN 11 is isolated
• B. Inteface vfc 5 is up and running for the assigned VSAN
• C. Trunk VSAN 11 is intializing
• D. VSAN to FC mapping is not working as expected

Answer: B

NEW QUESTION 3
Refer to the exhibit.

Which statement about the configuration is true?

• A. It provides an authoritative LISP site for IPv6 EID prefix 2110 cc8 a /48.
• B. It configures a single map resolver system.
• C. It creates a LISP site policy that requires active/standby service provider links for ingress traffic.
• D. It configures PxTR services for IPv6 EID prefix 2110:ccB:a::/48.

Answer: A

NEW QUESTION 4
In the dynamic vNIC creation wizard, why are choices for Protection important?

• A. They allow reserve vNICs to be allocated out of the spares pool.
• B. They enable hardware-based failover.
• C. They select the primary fabric association for dynamic vNICs.
• D. They allow dynamic vNICs to be reserved for fabric failove

Answer: C

Explanation: Number of Dynamic vNICs – This is the number of vNICs that will be available for dynamic assignment to VMs. Remember that the VIC has a limit to the number of vNICs that it can support and this is based on the number of uplinks between the IOM and the FI. At least this is the case with
the 2104 IOM and the M81KR VIC, which supports ((# IOM Links * 15) – 2)). Also remember that your ESXi server will already have a number of vNICs used for other traffic such as Mgmt, vMotion,
storage, etc, and that these count against the limit.
Adapter Policy – This determines the vNIC adapter config (HW queue config, TCP offload, etc) and you must select VMWarePassThru to support VM-FEX in High Performance mode.
Protection – This determines the initial placement of the vNICs, either all of them are placed on fabric A or Fabric B or they are alternated between the two fabrics if you just select the “Protected” option. Failover is always enabled on these vNICs and there is no way to disable the protection. Reference:
http://infrastructureadventures.com/2011/10/09/deploying-cisco-ucs-vm-fex-for-vsphere-
%E2%80%93-part-2-ucsm-config-and-vmware-integration/

NEW QUESTION 5
What mode is required on a Cisco Nexus 7000 32-port 10-GB module port group to allow equal access to the 10-GB port controller?

• A. dedicated
• B. assigned
• C. shared
• D. community

Answer: C

Explanation: You can share 10 Gb of bandwidth among a group of ports (four ports) on a 32-port 10-Gigabit Ethernet module. To share the bandwidth, you must bring the dedicated port administratively down, specify the ports that are to share the bandwidth, change the rate mode to shared, and then bring the ports administratively up.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/5_x/nxos/ interfaces/configuration/guide/if_cli/if_basic.html#70242

NEW QUESTION 6
Which item represents the process that allows FCoE multihop using T11 standard FC-BB-5?

• A. distributed FCF
• B. FIP proxy
• C. N Port proxy
• D. FIP snooping

Answer: D

Explanation: FIP snooping is used in multi-hop FCoE environments. FIP snooping is a frame inspection method that can be used by FIP snooping capable DCB devices to monitor FIP frames and apply policies based on the information in those frames. This allows for:
Enhanced FCoE security (Prevents FCoE MAC spoofing.) Creates FC point-to-point links within the Ethernet LAN
Allows auto-configuration of ACLs based on name server information read in the FIP frames Reference:
http://www.definethecloud.net/fcoe-initialization-protocol-fip-deep-dive/

NEW QUESTION 7
Which two Nexus family line cards allow the configuration of features regarding LISP, OTV and MPLS? (Choose two.)

• A. B1
• B. F3
• C. F2
• D. F1
• E. M2

Answer: BE

NEW QUESTION 8
Which option describes the atomic rollback feature in Cisco NX-OS?

• A. Rollback is implemented only if no errors occur.
• B. Rollback is implemented and any errors are skipped.
• C. Rollback is implemented and stops if an error occurs.
• D. Rollback is implemented instantly and there is no option to cancel the operation if errors are encountered.

Answer: A

NEW QUESTION 9
Which security feature is only supported on the Cisco Nexus 7000 Series Switch?

• A. Dynamic ARP Inspection
• B. NAC
• C. CoPP
• D. IP source guard

Answer: B

NEW QUESTION 10
Between which two types of ports does FIP establish Fibre Channel virtual links? (Choose two.)

• A. VE Ports and VE Ports
• B. N Ports and F Ports
• C. VN Ports and VF Ports
• D. VP Ports and VE Ports
• E. VE Ports and VF Ports
• F. E Ports and E Ports

Answer: AC

Explanation: FIP aims to establish virtual FC links between VN_Ports and VF_Ports (ENode to FCF), as well as between pairs of VE_Ports (FCF to FCF), since these are the only legal combinations supported by native Fibre Channel fabrics. Standards-compliant implementations are not required to support both forms of virtual FC links, and Cisco has decided to focus initially on implementing FIP only between ENodes and FCFs. FCF-to-FCF connectivity is considered a strategic direction for end-to-end FCoE deployments, but the short-term urgency is for FCoE adoption between CNAs and the Fibre Channel fabric perimeter, where unified fabric can offer the greatest capital expenditure (CapEx) savings today.
Reference:
http://www.cisco.com/c/en/us/products/collateral/switches/nexus-7000-seriesswitches/ white_paper_c11-560403.html

NEW QUESTION 11
Which statement accurately describes MP-BGP EVPN?

• A. MP-BGP EVPN is a Layer 3 overlay alternative to VXLANs.
• B. The control plane of the VXLAN overcomes the flood-and-learn limitations of MP-BGP EVPN.
• C. The MP-BGP EVPN control plane overcomes the flood-and-learn limitations of the VXLAN.
• D. MP-BGP EVPN is a Layer 2 overlay alternative to VXLAN

Answer: C

NEW QUESTION 12
Which three items must be configured in the port profile client in Cisco UCS Manager? (Choose three.)

• A. port profile
• B. DVS
• C. data center
• D. folder
• E. vCenter IP address
• F. VM port group

Answer: BCD

Explanation: After associating an ESX host to a DVS, you can migrate existing VMs from the vSwitch to the DVS, and you can create VMs to use the DVS instead of the vSwitch. With the hardware-based VN-Link implementation, when a VM uses the DVS, all VM traffic passes through the DVS and ASIC-based switching is performed by the fabric interconnect.
In Cisco UCS Manager, DVSes are organized in the following hierarchy: vCenter
Folder (optional) Datacenter Folder (required) DVS
At the top of the hierarchy is the vCenter, which represents a VMware vCenter instance. Each vCenter contains one or more datacenters, and optionally vCenter folders with which you can organize the
datacenters. Each datacenter contains one or more required datacenter folders. Datacenter folders contain the DVSes.
Reference: http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/gui/config/guide/1-3-
1/b_UCSM_GUI_Configuration_Guide_1_3_1/UCSM_GUI_Configuration_Guide_1_3_1_chapter28.h tml

NEW QUESTION 13
Which technology facilitates a nondisruptive upgrade on a Cisco Nexus 5000 Series Switch?

• A. VSS
• B. ITD
• C. VDC
• D. vPC

Answer: D

NEW QUESTION 14
When implementing Cisco Adapter FEX, which setting on the virtual interface card on the Cisco UCS C-Series Server must be configured?

• A. uplink failover
• B. PXE boot
• C. network interface virtualization
• D. VM-FEX

Answer: C

NEW QUESTION 15
Which command specifies a load-balancing method based on the MAC address of a host where the same forwarder is always used for a particular host while the number of GLBP group members remains unchanged?

• A. load-balancing host-dependent
• B. load-balancing mac-pinning
• C. load-balancing round-robin
• D. load-balancing weighted

Answer: A

NEW QUESTION 16
Which of the following Cisco Nexus features is best managed with DCNM-LAN?

• A. VSS
• B. Domain parameters
• C. Virtual switches
• D. AAA

Answer: C

Explanation: DCNM-LAN supports the following platforms:
• Cisco Nexus 1000V switches
• Cisco Nexus 2000 Fabric Extenders
• Cisco Nexus 3000 Series switches
• Cisco Nexus 4000 Series switches
• Cisco Nexus 5000 Series switches
• Catalyst 6500
DCNM-LAN provides limited support for the Catalyst 6500 Series switches that runs classic IOS version 12.2(33)SXI or higher.
– DCNM-LAN supports the viewing of the current configuration attributes of the device.
– DCNM-LAN does not support changing the configuration of the device.
– DCNM-LAN supports the Firewall Service Module (FWSM) version 4.0 or higher for the Catalyst 6500 Series switches.
• Cisco Nexus 7000 Series switches Reference:
http://www.cisco.com/c/en/us/td/docs/switches/datacenter/mds9000/sw/5_2/configuration/guides
/fund/DCNM-SAN-LAN_5_2/DCNM_Fundamentals/fund_overview.html

NEW QUESTION 17
Which two statements about the VRRP are true? (Choose two.)

• A. VRRP allows the traffic load to be shared through the use of multiple VRRP groups.
• B. When the VRRP is configured to track a Layer 2 interface, the VRRP priority instantly refilects the state of the Layer 2 interface.
• C. The BFD for the VRRP can be configured only between two Cisco Nexus switches
• D. vPC can forward traffic through both VRRP devices.
• E. The VRRP can be configured on the management interfac

Answer: AD

NEW QUESTION 18
Which four statements about reserved VLANs in Cisco NX-OS are true? (Choose four.)

• A. The range of reserved VLANs cannot be changed.
• B. The number of reserved VLANs is 96.
• C. A change to the range of reserved VLANs can be performed only in the VDC default.
• D. A write-erase procedure restores the default reserved VLAN range.
• E. The number of reserved VLANs is 128.
• F. A reload is needed for changes to take place.
• G. The configuration must be saved for changes to take plac

Answer: CEFG