NEW QUESTION 1
What is first preference condition matched in a SIP-enabled incoming dial peer?

• A. incoming uri
• B. target carrier-id
• C. answer-address
• D. incoming called-number

Answer: A

NEW QUESTION 2
Configure Call Queuing in Cisco Unified Communications Manager. Where do you set the maximum number of callers in the queue?

• A. in the telephony service configuration
• B. in the queuing configuration
• C. in Cisco Unified CM Enterprise Parameters
• D. in Cisco Unified CM Service Parameters

Answer: B

NEW QUESTION 3
What are the elements for Device Mobility configuration?

• A. physical location, device pool, and Device Mobility group
• B. device pool, Device Mobility group, and region
• C. physical locatio
• D. Device Mobility group, and region
• E. device pool, Device Mobility group, and Cisco IP phone

Answer: A

NEW QUESTION 4

Refer to the exhibit. Within the North American Numbering Plan, gateways located in Ottawa, Canada and marked as “YOW” are assigned to the Calling Party Transformation CSS NANP_CgPTP, which contains partition NANP_calling_xforms. What is the calling-party number and the numbering type if the calling user +1613-555-1234 dials the number?

• A. calling number 613-555-1234 and numbering type “subscriber”
• B. calling number 011-1-613-555-1234 and numbering type “subscriber”
• C. calling number 011613-555-1234 and numbering type “international”
• D. calling number 613-555-1234 and numbering type “national”

Answer: D

NEW QUESTION 5

Refer to the exhibit. Users report that when they dial the emergency number 9911 from any internal phone, it takes a long time to connect with the emergency operator. Which action resolves this issue?

• A. Adjust the service parameter T302 timet to the desired value.
• B. Adjust the service parameter T204 timer to the desired value.
• C. Check the Urgent Priority check box under 9.911 pattern.
• D. Point the emergency pattern directly to the PSTN gateway.

Answer: C

NEW QUESTION 6
Which configuration element of a hunt group allows for changing Calling Party Transformations settings?

• A. line group
• B. hunt pilot
• C. route group
• D. hunt list

Answer: B

NEW QUESTION 7
When the services key is pressed Cisco Extension Mobility does not show up. What is the cause of the issue?

• A. The URL configured for Cisco Extension Mobility is not correct.
• B. Cisco Extension Mobility Service is not running.
• C. The phone is not subscribed to Cisco Extension Mobility Service.
• D. Cisco Extension Mobility is not enabled in the Phone Configuration Window (Device > Phone)

Answer: C

NEW QUESTION 8
An engineer is configuring a call park feature in Cisco Unified Communications Manager Express. Which command does the engineer use to ensure that the call is reverted to the user after 60 seconds?

• A. R2(config-ephone-dn)#park reservation-group 60
• B. R2(config-ephone-dn)#park-slot timeout 60 limit 2 recall alternate 3002
• C. R2(config-ephone-dn)#park reservation-group 1
• D. R2(config-ephone-dn)#park-slot timeout 30 limit 2 recall alternate 3002

Answer: B

NEW QUESTION 9

Refer to the exhibit. Calls incoming from the provider are not working through newly set up Cisco Unified Border Element. Provider engineers get the 404 Not Found SIP message. Incoming calls are coming from the provider with called number “222333444” and Cisco Unified Communications Manager is expecting the called number to be delivered as “444333222”. The administrator already verified that the IP address of the Cisco Unified CM is set up correctly and there are no dial peers configured other than those shown in the exhibit. Which action must the administrator take to fix the issue?

• A. Change the destination-pattern on the outgoing dial peer to match “444333222”.
• B. Set up translation-profile on the incoming dial peer to match incoming traffic.
• C. Create specific matching for “222333444” on the incoming dial peer.
• D. Fix the voice translation-rule to match specifically number “222333444” and change it to “444333222”.

Answer: B

NEW QUESTION 10
A user in location X dials an extension at location Y. The call travels through a QoS-enabled WAN network, but the user experiences choppy or clipped audio. What is the cause of this issue?

• A. missing Call Admission Control
• B. codec mismatch
• C. ptime mismatch
• D. phone class of service issue

Answer: B

NEW QUESTION 11

Refer to the exhibit. Users report that when they dial to Cisco Unity Connection from an external network, they cannot enter any digits. Assuming only in-band DTMF is supported, what is a reason for this malfunction?

• A. The negotiated RTP port is outside of the range described by RFC, so inband DTMFs do not work.
• B. There is SIP Delayed Offe
• C. DTMF is supported only in Early Offer.
• D. The rtpmap:0 value for the negotiated codec is marking DTMF as inactive.
• E. No DTMF is negotiated.

Answer: D

NEW QUESTION 12
End users at a new site report being unable to hear the remote party when calling or being called by users at headquarters. Calls to and from the PSTN work as expected. To investigate the SIP signaling to troubleshoot the problem, which field can provide a hint for troubleshooting?

• A. Contact: header of the 200 OK response
• B. Allow: header if the 200 OK response
• C. o= line of SDP content
• D. c= line of SDP content

Answer: C

NEW QUESTION 13
An engineer must configure a secure SIP trunk with a remote provider, with a specific requirement to use port 5065 for inbound and otubound traffic. Which two items must be configured to complete this configuration? (Choose two.)

• A. Incoming Port in SIP Information section of the SIP Trunk configuration.
• B. Incoming Port in Security Information of the SIP Profile configuration.
• C. Destination Port in SIP Information section of the SIP Trunk configuration
• D. Incoming Port in SIP Trunk Security Profile configuration
• E. Destination Port in SIP Trunk Security Profile configuration

Answer: CD

NEW QUESTION 14
Which two types of distribution algorithm are within a line group? (Choose two.)

• A. random
• B. circular
• C. highest preference
• D. top down
• E. bottom up

Answer: BD

NEW QUESTION 15
Why would RTP traffic that is sent from the originating endpoint fail to be received on the far endpoint?

• A. The far end connection data (c=) in the SDP was overwritten by deep packet inspection in the call signaling path.
• B. Cisco Unified Communications Manager invoked media termination point resources.
• C. The RTP traffic is arriving beyond the jitter buffer on the receiving end.
• D. A firewall in the media path is blocking TCP ports 16384-32768.

Answer: D

NEW QUESTION 16
Which two types of authentication are supported for the configuration of Intercluster Lookup Service? (Choose two.)

• A. TokenID
• B. username and secret key
• C. TLS certificates
• D. passwords
• E. FQDN of the servers defined in DNS

Answer: CD

NEW QUESTION 17
Which two configuration parameters are prerequisites to set Native Call Queuing on Cisco Unified Communications Manager? (Choose two.)

• A. Cisco IP Voice Media Streaming Service must be activated on at least one node in the cluster.
• B. A unicast music on hold audio source must be configured.
• C. Cisco RIS data collector service must be running on the same server as the Cisco CallManager service.
• D. The maximum number of callers allowed in queue must be 10.
• E. The phone button template must have the Queue Status Softkey configured.

Answer: AC

NEW QUESTION 18
How does an engineer globalize routing for ingress calls coming from the PSTN to internal DNs?

• A. At the PSTN gateway, put the calling number in PSTN format and the called number in DN format.
• B. At Cisco Unified CM, put the calling number in E.164 format and the called number in PSTN format.
• C. At the PSTN gateway, put the calling number in E.164 format and the called number in localized (DN) format.
• D. At Cisco Unified Communications Manager, put the calling number in E.164 format and the called number in E.164 format.

Answer: B

NEW QUESTION 19
Which call pickup feature allows users to pick up incoming calls in a group that is associated with their own group?

• A. Other Group Pickup
• B. BLF Call Pickup
• C. Group Call Pickup
• D. Directed Call Pickup

Answer: A

NEW QUESTION 20
A user reports that when they attempt to log out from the Cisco Extension Mobility service by pressing the Services button, they cannot log out. What is the most likely cause of this issue?

• A. The Cisco Extension Mobility service has not been configured on the phone.
• B. There might be a significant delay between the button being pressed and the Cisco Extension Mobility service recognizing i
• C. It would be best to check network latency.
• D. The user device profile has not been assigned to the user.
• E. The user device profile is not subscribed to the Cisco Extension Mobility service.

Answer: D

NEW QUESTION 21
Refer to the exhibit. An engineer configures Cisco Unified Border Element to connect the enterprise VoIP network with a SIP telephony provider. Calls are not working in either direction. What must be configured in the dial peer 1 to fix the issue?

• A. address 555 ……..
• B. codec g729
• C. session-protocol sipv2
• D. incoming called number 555…….

Answer: D

NEW QUESTION 22
Which IOS command creates a SIP- enabled dial peer?

• A. voice dial-peer 20 sip
• B. dial-peer voice 20 voip
• C. dial-peer voice 20 pots
• D. dial peer voice 20 sip

Answer: B

NEW QUESTION 23
......