Master the 200 355 wifund Implementing Cisco Wireless Network Fundamentals content and be ready for exam day success quickly with this Pass4sure ccna wireless 200 355 pdf download exam answers. We guarantee it!We make it a reality and give you real ccna wireless 200 355 pdf questions in our Cisco ccna wireless 200 355 dumps braindumps.Latest 100% VALID Cisco 200 355 vce Exam Questions Dumps at below page. You can use our Cisco ccna wireless 200 355 dumps braindumps and pass your exam.
Q191. Which two formats are available for Cisco WCS reports? (Choose two.)
A. PDF
B. CSV
C. HTML
D. TXT
Answer: A,B
Q192. Which two Cisco Unified Wireless Network capabilities use information that is provided by Radio Resource Management neighbor messages in version 7.0 MR1? (Choose two.)
A. aggressive load balancing
B. dynamic channel assignment
C. hybrid remote edge access point
D. inter-controller mobility (that is, mobility groups)
E. rogue AP classification
Answer: B,E
Q193. To implement a more secure means of communication for voice and data, what technology successfully resists interference by utilizing a wider bandwidth than needed for the transmitting signal?
A. Spread Spectrum
B. Microwave
C. Extended U-NII2
D. ISM Bands
Answer: A
Q194. Refer to the exhibit. An engineer wants to setup a mobility anchor for the Guest WLAN, but does not see the Anchor IP address listed in the drop-down. What is the most likely cause of this problem?
A. The mobility anchor is currently unreachable.
B. The mobility anchor must also be included in the mobility group of the WLC.
C. Layer 3 Security must be configured for Web Policy Authentication.
D. The mobility anchor is attached to another WLAN.
E. Layer 3 Security must be configured for Web Policy Passthrough.
Answer: B
Q195. Which CLI command is used on a Cisco WLC to troubleshoot mobility, rogue detection, and load-balancing events?
A. debug dot11
B. debug capwap all
C. show dot11 details
D. show capwap details
Answer: A
Q196. The administrator has noticed that the configuration on a controller is different than in Cisco WCS. How can the administrator fix this issue?
A. The configuration can be copied from the controller to the Cisco WCS or from the WCS to the controller.
B. The configuration can be copied only from the Cisco WCS to the controller.
C. The configuration can be copied only from the controller to the Cisco WCS.
D. The controller must be removed from the Cisco WCS and then added again.
Answer: A
Q197. Which two statements about WiMAX technology are true? (Choose two.)
A. WiMAX is defined by 802.11i.
B. Typically, fixed WiMAX networks have a higher-gain directional antenna installed near the client.
C. WiMAX is capable of working as a long-range system over several miles.
D. WiMAX works only for licensed frequencies.
Answer: B,C
Q198. What is an MBSSID?
A. a virtual AP configured on a physical AP that share a single physical device, which is one half-duplex radio
B. a set of physical APs configured in a BSA to form cells that are controlled by a single controller
C. the group of clients that are allowed to gain access to one or more SSIDs configured in an AP
D. the identified overlap area between two cells, which identifies the clients that are operating in that area at any given time
Answer: A
Q199. Old 2.4-GHz wireless laptops are unable to connect. What is the most likely cause of this problem?
A. WLAN > General properties are incorrectly configured.
B. WLAN > QoS properties are incorrectly configured.
C. WLAN > Security properties are incorrectly configured.
D. WLAN > Advanced properties are incorrectly configured.
E. Wireless > AP > 802.11 b/g/n AP is incorrectly configured.
F. Wireless > AP > 802.11 b/g/n > Network is incorrectly configured.
Answer: F
Q200. What 802.1x role is responsible for moving a port to the authorized state?
A. Supplicant
B. Authenticator
C. Authentication Server
D. RADIUS Server
Answer: B